Neeeed Help !!.. Badly

[tyson.corkum]

Hey guys, I really need some help i tried a pour this morning, heated it and heated it and heated it, but it never thickened :mad: , How Do you get it to thicken up, any help would be nice..! Thanks Tyson..

[Delw]

Tyson.

you need to shake the plastic up very good first,
then you need to heat the plastic till it starts to turn clear and gel,
after that heat a little while longer till its pourable.

shoot me your phone number over in a pm and I can guide you through it on the phone its much easier, or call the shop and leave a number so I can call you back.
623-931-9405

[tyson.corkum]

Delw,

When the plastic turns clear and gel, do i stir it before i heat it again?

[BB Nitro]

I do, when it get's clear and lumpy, I stop it, give it a stir, and out it back for another 30-60sec. urn a few so you get the "feel" of how HOT and how FAST you can heat it. I have a GIANT microwave and I think I have to stop and stir every 30 after the first minute just so I don't heat it too fast = burn. Go ahead and burn one, so you get the "feel" of how far you can push it.

* Once plastic is burned, set it outside until completely cooled (BAD smoke/fumes)=cancer